Main Content

Homes That Were Flooded May Harbor Mold Problems

Release date: 
May 3, 2001
Release Number: 

Quincy, MA -- The flooding happened more than a month ago, but Massachusetts residents may still face some serious cleanup problems, advise federal and state officials.

"Be careful when cleaning mold," said Louis H. Botta, the Federal Emergency Management Agency (FEMA) official who is the federal coordinating officer for the disaster recovery effort. Bristol, Essex, Middlesex, Norfolk, Plymouth, Suffolk and Worcester counties are under a federal disaster declaration after severe storms and flooding between March 5 and April 16.

Molds are simple microscopic organisms found virtually everywhere, indoors and outdoors. When mold is present in large quantities it can result in allergic symptoms similar to those caused by plant pollen.

Be aware that exposure to mold can occur during cleanup. To minimize exposure, use a mask or respirator, wear rubber gloves and take breaks in a well ventilated area.

"You should be concerned about mold if the amount is extensive," said Stephen J. McGrail, director of the Massachusetts Emergency Management Agency and state coordinating officer.

When airborne mold spores are present in large numbers they can cause allergic reactions, asthma episodes, infections, and other respiratory problems. People who are at higher risk from the effects of mold include infants and children; the elderly; people with compromised immune systems because of HIV infection, liver disease, or in chemotherapy; pregnant women; and people with existing respiratory conditions such as allergies, multiple chemical sensitivity, and asthma. People with these conditions should consult a physician if they are experiencing health problems.

Here are some tips for cleaning mold:

  • Identify and correct the moisture source. Then clean, disinfect, and dry the moldy area. Keep the area well ventilated and dispose of anything that has moldy residue, such as rags, paper, leaves or debris.
  • Porous materials can trap molds. Items such as paper, rags, wallboard and rotten wood should be thrown out. Harder materials such as glass, plastic and metal can be kept after they are cleaned and disinfected.
  • Wear protective gloves, such as rubber dishwashing gloves, when working with moldy materials. Remove and discard porous materials such as ceiling tiles, drywall, carpeting, wood products.
  • Carpeting can be a difficult problem. Drying does not remove the dead mold spores. If there is heavy mold on the carpet, the best course of action may be to discard it. If the area was flooded, remove drywall to at least 12 inches above the high water mark. Allow the area to dry two or three days before replacing damaged materials.
  • Wear protective gloves when cleaning mold. Use non-ammonia soap or detergent, or a commercial cleaner in hot water. Scrub the entire affected area thoroughly using a stiff brush or cleaning pad. Then rinse with clean water.
  • Wear protective gloves when using disinfectants. After thorough cleaning and rinsing, disinfect the area with a solution of 10 percent household bleach (11/2 cups bleach per gallon of water). Never mix bleach with ammonia. The fumes are toxic. Allow disinfecting areas to dry naturally overnight to kill all mold.

This News Release was Edited on June 27, 2005

Last Updated: 
January 3, 2018 - 13:01